MAHLE VCT Manual De Usuario página 8

14
VCT Ozone Generator
Use and maintenance manual
to prevent physical injury, electrical shock
or malfunctioning of the equipment.
Do not use the equipment in
n
+ Saline, humid or wet environments
+ Proximity of aggressive vapours, flam
mable substances
+ ATEX potential explosive atmosphere/
area
Do not use the equipment with presence in-
n
side the vehicle/rooms cabin/interior of gas
appliances, heating devices with flames or
ignition systems.
n Do not use the equipment with presence
inside the vehicle/rooms cabin/interior of
products as:
+ Flammable or dangerous substances
+ Food and drinks
+ Medicines
If the power socket used to power the
n
equipment has poor connections, the plug
of the equipment becomes hot. Make sure
that you plug the equipment into a properly
connected power socket.
Always place and use the equipment on a
n
dry, stable, level, and horizontal surface.
n The equipment must be located at least
20 cm from any potential obstacles (in par-
ticular to prevent hindrances to air suction,
ozone emission and cooling).
Do not use the equipment in a room with
n
major temperature changes, as this may
cause condensation inside the equipment.
Always unplug the equipment after use and
n
before handling, cleaning or carrying out
maintenance.
When using the equipment, the following opera-
tions are not allowed as they might cause, under
certain circumstances, danger for persons and
cause permanent damage to the equipment it-
self.
Do not remove or make unreadable labels, signs
and/or dangers signs placed on the equipment
and in the area nearby.
Do not disable the unit's safety equipment.
A fuse is present in the plug of the 12VDC cig-
arette lighter cable. Use only fuses identical to
the originals as specified on the nameplate; do
not tamper with or attempt to repair the fuses. If
the power supply is known or can be expected
to vary beyond the limits specified for the service
equipment, immediately disconnect it.
The electrical system to which the service equip-
ment is connected must be configured as pro-
vided by local legislation.
Only operators or qualified staff instructed or cer-
tified for the equipment maintenance can open
the equipment. The equipment contains parts
which can cause electrocution: shut off power to
the equipment before servicing/repairing it.
15
Maintenance/general cleaning: The equip-
ment maintenance has to be performed accord-
ing to the procedures described in this manual
and to the current safety regulations.
External cleaning of the equipment shall be made
using dry cloths without use of any substance.
Updated information/requirements on O3 ozone
safety are available on the official website of
ECHA European Chemicals Agency
Websites:
n https://echa.europa.eu/
https://echa.europa.eu/it/registration-dos-
n
sier/-/registered-dossier/22480/9
For O3 ozone gas in particular, requirements
are available on the following topics
First aid measures
n
Fire-fighting measures
n
Accidental release measures
n