ARENDO 303759 Manual Del Usuario página 23

5. Usage
Press the lid opener to open the tiltable lid. Fill the kettle with cold water and press
the lid down until it locks into place.
Note: A scale is provided on the inside. Do not fill the container above the maximum
mark. The boiling water may spurt out if the kettle is overfilled.
Then, place the kettle on the base plate.
5.1 Boiling water directly
If you want to boil the water directly to 100°C, then press the "ON/OFF" button.
The "BOIL" icon flashes for about 4 seconds in the display. The kettle then indicates
the start of boiling by beeping 2 times.
Important! Boiling can be cancelled at any time by pressing the ON/OFF button
again!
Once the water reaches the target temperature, the kettle indicates it by beeping
3 times. The heating element switches off automatically and the boiling process is
stopped. The appliance can now be lifted and the water can be used.
5.2 Heating water based on target temperature (40/80/90°C)
To heat the water to the desired target temperature, press the "Mode" button (
).
The kettle flashes the currently selected temperature and the "BOIL" mode on the
display. The following temperatures are available for selection: M1 - 40°C, M2 -
80°C and M3 - 90°C.
23
English