J.P. SELECTA PLAC-CENTER Manual De Instrucciones página 11

INSTRUCTION MANUAL
J
.P. SELECTA s.a.u.
CODE 80052 REV E
STARTING UP:
Before the introduction of the first load, it is advisable to leave the
equipment working for about two hours at the preset temperature.
OPERATION:
1. Connect the plate to the mains.
2. Press the main switch (1).
3. Adjust set point (SP).
2
1
SET key (5): press for 5 seconds to vary the SP (Set Point). Modify
with the Up (6) and Down (7) keys to select the setpoint temperature.
Validate by pressing the SET key (5) again. The stabilization time at the
desired temperature will vary depending on the ambient temperature.
Up key (6): press for 5 seconds to start or stop defrosting. In the pro-
gramming menu it is possible to move through the different levels, and
to vary a parameter when adjusting it.
Down key (7): press for 5 seconds to activate Stand-by mode. To re-
turn to normal mode, press again for 2 seconds. In Stand-by mode,
the equipment does not perform any action and only the indicator (1) is
shown on the screen.
In the programming menu, it allows you to scroll through the different
levels, and to vary a parameter when adjusting it.
Indicator leds and keys:
1. Stand-by mode indicator
2. Programming mode indicator
3. Display
4. Active Cooling Indicator
5. SET key
6. Up / Defrost key
7. Down / Stand-by key
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es http://www.grupo-selecta.com
3 4
03/2021
5
6
7
Tel (34) 93 770 08 77 Fax (34) 93 770 23 62
Page: 11