RIB VERTIGO Wi-Fi 8 Manual Del Usuario página 17

INFRARED SIGNAL RECEIVER - RX
RECEIVER IDENTIFICATION
Every pair of VERTIGO Wi-Fi photocells is supplied with the micro-switches in the OFF position.
Every pair of VERTIGO Wi-Fi photocells must OBLIGATORILY be unequivocally identified by
placing only one of its 6 DIPs (SWRX) into the ON position.
Example: set DIP 1 to ON on the MASTER Wi-Fi and DIP 1 to ON on the VERTIGO Wi-Fi receiver (the
same DIP set on the transmitter).
ASSEMBLY OF THE INFRARED RECEIVER
- Separate the cover with the rubber support (7) from the base (8) and remove the electronic
board (9) (Fig. 6).
- Place the base (8) on the upper border of the leaf of the gate (at a maximum distance of 3
metres from the transmitter).
- Fasten it immediately using 2 self-tapping screws TCCR3,5X16 supplied (10).
- Check that the gasket is present and it is intact within the cover (7).
- If necessary, rotate the bellows assembly which includes the lens by 90°, so to direct the
infrared ray as per need (VERTIGO Wi-Fi comes with the infrared ray set as per Fig. 6).
It is possible to direct the ray according to the needs:
- Insert the electronic board already mentioned, linked to the cover with the bellow, in the
special rails on the base.
- Insert the batteries paying attention to the polarity (Fig. 8).
- When the batteries are inserted into the receiver the DLRX red led (Fig. 5) lights on for 3
seconds, indicating the proper functioning.
CARRY OUT THE STORAGE PROCEDURE
AS SPECIFIED IN THE PARAGRAPH "STORAGE"
(see next page)
RECEIVER
SETTINGS AND CONNECTIONS
J2 Connector
for connecting the
receiver diode
BAT Alkaline batteries
2 x AA 1,5V
SWRX Dips for coordination and
identification
DLRX Red LED indicating correct power
and infrared signal alignment
S3 PROG Push-button for memorization and
alignment
RX
6
17
RX
-
+
7
G
B
J2
BAT
SWRX
DLRX
S3
5
8