Installation - Klarstein 10030683 Manual Del Usario

INSTALLATION

Cut out the work surface according to the sizes shown in the drawing. For the purpose
of installation and use, a minimum of 5 cm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant
work surface material to avoid larger deformation caused by the heat radiation from the
hotplate. As shown below:
L (mm) W (mm)
288 520
Installation of the foam gasket
Do not install the hob without the foam gasket. The gasket should be fitted to the hob as
follows:
• Remove the protective film from the gasket.
• Then attach the gasket to the bottom of the glass next to the edge.
• The gasket must be fitted along the entire length of the edge of the glass and must
not overlap at the corners.
• When fitting the gasket, ensure that the glass does not come into contact with sharp
objects.
H (mm) D (mm) A (mm)
52 48 265+5
Gasket
B (mm) X (mm)
495+5 50 min
EN
23