STERWINS 1000 WP CE 4I-3 Instrucciones Para El Uso página 135

OPERATION
• Submerge the pump at an angle into the liquid to be delivered so that no air pocket forms
on the underside of the appliance. This would prevent suction. Once the pump is submerged,
it can be placed upright again.
• Leave the pump on the bottom of the liquid container. Use a strong rope attached to the
carrying handle of the pump for lowering.
• Tighten the end of the rope firmly after lowering.
The pump can also be operated while suspended on a rope.
Operation
The pump can be operated after it has been connected to the mains power supply.
Attention!
EN
Note:
For operation with rope: Do not operate the pump without the pressure hose.
Ensure that the pump does not twist around its longitudinal axis.
Risk of damage to the appliance
The float switch must be able to move so that the submersible pump
cannot run without water.
134