Promax MZ-805 Manual De Instrucciones página 89

MZ-805 L/C/R meter
System Commands
*RST
*RCL <nr1>
*SAV <nr1>
Status Commands
*LRN?
LRN
<character
data>
Miscellaneous Commands
*IDN?
Calibration Specific Commands
See Service Manual for details of calibration specific commands.
August 2002
Resets the instrument to the power-up default settings.
Recalls the instrument set—up contained in store
number <nr1>. Valid store numbers are 0 - 9. Recalling
store 0 sets all parameters to the power-up default
settings. An attempt to recall from a store which has
not been previously loaded with a set—up will cause an
error.
Saves the complete instrument set—up in store number
<nr1>. Valid store numbers are 1 — 9.
Returns the complete set up of the instrument as a
hexadecimal character data block. The syntax of the
response is LRN <data><rmt>.
To re—install the set—up return the block exactly as
received, including the LRN header at the beginning of
the block, see below. The settings in the instrument
are not affected by execution of the *LRN? command.
Install data from a previous *LRN? command. Note
that the LRN header is provided by the *LRN?
response block.
Returns the instrument identification. The exact
response is determined by the instrument configuration
and is of the
<version><rmt> where <NAME> is the manufacturer's
name, <model> defines the type of instrument and
<version> is the revision level of the software installed.
form <NAME>,<model>,0,
Page 35