3. Intended use or uses of the construction product, in accordance with the applicable harmonised technical specification, as foreseen by the manufacturer:

Residential space heating appliance, with water, fired by wood pellets

4. Name, registered trade name or registered trademark and contact address of the manufacturer as required by Art. 11 (5):

Ravelli

Aico S.p.A.

Via A. Kupfer, 31

25036 Palazzolo s/O (Bs) Italia

5. Where applicable, name and contact address of the authorised representative whose mandate covers the tasks specified in Article 12(2):

---

6. System or systems of assessment and verification of constancy of performance of the construction product as set out in Annex V:

System 3, System 4

7. In case of the declaration of performance concerning a construction product covered by a harmonised standard:

The notified laboratory IMQ (NB 0051) performed the determination of the product type on the basis of type testing under system 3 and issued

test report CS18-0030646-01

8. Declared performances:

Harmonized technical specification:

Essential characteristics

Fire safety

Reaction to fire

Distance to combustible materials

Risk of burning fuel falling out

Emission of combustion products

(at 13% of O

)

Surface temperature

Electrical safety

Cleanability

Maximum operating pressure

Flue gas temperature at nominal heat output

Mechanical resistance(to carry a chimney/flue)

Nominal heat output

Room heating output

Water heating output

Efficiency

9. The performance of the product identified in points 1 and 2 is in conformity with the declared performance in point 8. This declaration of performance

is issued under the sole responsibility of the manufacturer identified in point 4.

Place