Uline H-951 Manual Del Usuario página 3

To keep the Shrink Tunnel operating efficiently perform
the following:
• Monthly – Lubricate the conveyor chains with high
temperature oil. Apply with a brush or spray with
conveyor running slowly.
• Regularly inspect the silicone covering on the tunnel
rollers. Make sure no film is wrapped around rollers,
this could cause packages to stick.
TOOLS NEEDED
10 mm Socket
Socket Wrench
13 mm Socket
1. Remove outer corrugated box from pallet.
(See Figure 1)
Figure 1
2. Using 13 mm socket,
remove two bolts that
secure shrink tunnel to
pallet. (See Figure 2)
PAGE 3 OF 21
MAINTENANCE
INSTALLING LEG KIT USING FORKLIFT
INCLUDED HARDWARE
Bolt x 12
Figure 2
TO CLEAN:
1. Run conveyor until the affected rollers are inside the
heat chamber.
2. Let the heater soften the film residue on the rollers.
3. Advance the conveyor to stop the rollers outside the
heat chamber.
WARNING! Make sure conveyor is stopped
before placing hands or tools in the conveyor
area.
4. Remove the film residue with a dull blunt-edged tool
such as plastic putty knife. DO NOT use sharp tools or
instruments, you may nick the silicone covering and
have to replace it.
Washer x 12 Locking Washer x 12
3. Place forklift in front of
shrink tunnel with the
forks close together.
(See Figure 3)
4. With two people, lift
and slide tunnel onto
the forks. Once unit
is secured, raise the
forks upward to a
comfortable working
height. (See Figure 4)
Two Person Assembly
Recommended
Figure 3
Figure 4
0421 IH-951