This manual is intended to supplement the operator’s manual included with your machine. There is very important safety, operational and maintenance information in this manual. Read and understand all information in your operator’s manual and this supplement manual before attempting to operate this machine.
Features & Controls Instrument Control Panel Features & Controls (S/N: 2014953656 & Below) CONTROL FUNCTIONS The information below briefly describes the function of individual controls. Starting, stopping, driving, and mowing require the combined use of several controls applied in specific sequences. To learn what combination and sequence of controls to use for various tasks see the OPERATION section.
Página 5
Features & Controls FUEL TANK CONTROLS Parking Brake DISENGAGE Releases the parking brake. ENGAGE Locks the parking brake. Pull the parking brake lever back to engage the parking brake. Move the lever fully forward to disengage the parking brake. NOTE: To start the unit the parking brake must be engaged.
Operation Operation 6. After warming the engine, ALWAYS operate CHECKS BEFORE STARTING the unit at FULL THROTTLE when mowing. • Check that crankcase is filled to the full mark on In the event of an emergency the engine can be the dipstick.
Regular Maintenance RE-INSTALLING THE PROPANE TANKS NOTE: The propane tank should be installed on the unit so that the fuel shut-off valve and fuel level gauge are pointing toward the rear of the machine by the rear bumper. 1. Position the propane tank so that the tank positioning bracket (C, Figure 1) fits into the slots located on either side of the center slot.
Regular Maintenance LEAK TESTING THE FUEL SYSTEM 9. When you are done testing the system make sure that both fuel tank shut-off valves are CLOSED This procedure should only be used when trying to until you are ready to use the unit again. identify the location of a leak.
Specifications SPECIFICATIONS TRANSMISSIONS: (Pumps) Specifications are correct at time of printing and are Hydro-Gear PJ-12: subject to change without notice. 12cc Pumps fit models: S/N: 2014192366 - 2014192366 Hydro-Gear PR-16: ENGINE: 16cc Pumps fit models: 37HP DFI Models: 2015308756 & Below; All other models: S/N: 2014192367 - 2015308756) Briggs &...
Seguridad del Operador • Revise regularmente la tubería de suministro flexible. Seguridad del Operador Asegúrese de que esté en buenas condiciones. Reemplace los componentes dañados o que ADVERTENCIA presenten fugas. Evite sufrir lesiones graves o la muerte al operar un cortacésped con combustible de propano.
Funciones y Controles Funciones y Controles Panel de instrumentos de control (S/N: 2014953656 & Abajo) FUNCIONES DE CONTROL La siguiente información describe brevemente la función de cada uno de los controles. Arrancar, detenerse, conducir y podar el césped requieren del uso combinado de varios controles que se aplican en secuencias específicas.
Funciones y Controles CONTROLES DEL DEPÓSITO DE Freno de mano COMBUSTIBLE QUITAR Con eso se quita el freno de mano. ACCIONAR Con eso se fija el freno de mano. Jale la palanca del freno de mano para accionar el mismo y mueva la palanca completamente hacia adelante para quitarlo.
Operación 5. Después de arrancar el motor, permitir que el Operación motor se caliente durante al menos un minuto antes de iniciar la toma de fuerza o cambiar la REVISIONES ANTES DE conducción del jinete. ARRANCAR Caliente el motor dejándolo correr al menos un minuto antes de activar el interruptor PTO o conducir •...
Mantenimiento regular REINSTALACIÓN DE LOS DEPÓSITOS DE PROPANO NOTA: El depósito de propano se debe instalar en la unidad para que la válvula de corte de combustible y el indicador de nivel de combustible apunten hacia la parte posterior de la máquina cerca del parachoques. 1.
Mantenimiento regular PRUEBA DE FUGAS DEL SISTEMA 8. Repita los pasos 2 al 8 con la válvula de corte del depósito de combustible cerrada en el depósito DE COMBUSTIBLE de propano izquierdo y con la válvula de corte del Este procedimiento sólo se debe usar al intentar depósito de combustible abierta en el depósito de identificar la ubicación de una fuga.
Especificaciones ESPECIFICACIONES TRANSMISIONES: Bomba Las especificaciones son correctas al momento de la HydroGear PJ-12: impresión y están sujetas a cambios sin previo aviso. Modelos de bomba de 12cc: S/N: 2014192366 - 2014192366 Hydro-Gear PR-16: MOTOR Modelos de DFI: 2015308756 y Abajo; Pron otro modelos: S/N: 2014192367 - 2015308756 Briggs &...
Supplemental Parts List - Tank Mount Group Illustrated Parts Lists 5 , 27 RH side components Propane System Service Parts www.ferrisindustries.com...
Página 19
Supplemental Parts List - Tank Mount Group REF NO. PART NO. DESCRIPTION 5407570B MOUNT, TANK MOUNT, PROPANE, RH - RED 5407592B MOUNT, TANK MOUNT, PROPANE, LH - RED 5404213B PLATE, BRACKET, REGULATOR MOUNT, PROPANE - RED 5403947B PLATE, BRACKET, TANK MOUNT - RED 5403521B WELD, TANK MOUNT - LH (S/N: 2014953566 &...
Supplemental Parts List - Instrument Control Group S/N: 2014953566 & Below Oriented to be read from operator position. S/N: 2014953567 & Above Oriented to be read from operator position. Important Note: Unlabelled components are the same as above. www.ferrisindustries.com...
Página 21
Supplemental Parts List - Instrument Control Group REF NO. PART NO. DESCRIPTION 5020927 SWITCH, IGNITION, 6 POST (INCLUDES REF # 17 -19 5022180 SWITCH, BLADE ENGAGEMENT 5022222 RING, SWITCH RETAINER 5100996 HOUR METER, W/ SUPRESSOR 5101537 LEVER, THROTTLE CONTROL (S/N: 2014953566 & Below) 5101072 CABLE, THROTTLE, 52”...
Supplemental Parts List - Fuel Supply Group (S/N: 2014953566 & Below) FRONT FRONT See Hydraulic Group REGULATOR 28 - “Soft Plug, IMPCO Propane Regulator” ENGINE www.ferrisindustries.com...
Página 23
Supplemental Parts List - Fuel Supply Group (S/N: 2014953566 & Below) REF NO. PART NO. DESCRIPTION 5101707 TANK, ALUMINUM, PROPANE 5023268 CLAMP, HOSE 5050860X29 HOSE, 3/8” PUSH-LOCK, 29.00” 5050861X25 WIRE LOOM, 5/8” ID, 25” LONG 5101430 RELIEF VALVE, PROPANE 5101570 FITTING, 1/4 NPT STREET ELBOW, PLATED STEEL 5101440 FITTING, 3/8 HOSE BARB X 1/4NPT, BRASS...
Página 24
Supplemental Parts List - Fuel Supply Group (S/N: 2014953567 & Above) FRONT FRONT See Hydraulic Group Hydraulic Pump To RH Hydraulic Pump To Oil Cooler REGULATOR 28 - “Soft Plug, IMPCO Propane Regulator” ENGINE Spanish English www.ferrisindustries.com...
Página 25
Supplemental Parts List - Fuel Supply Group (S/N: 2014953567 & Above) REF NO. PART NO. DESCRIPTION 5101707 TANK, ALUMINUM, PROPANE 5023268 CLAMP, HOSE 5050860X16 HOSE, 3/8” PUSH-LOCK, 16.00” 5050861X25 WIRE LOOM, 5/8” ID, 25” LONG 5101430 RELIEF VALVE, PROPANE 5101570 FITTING, 1/4 NPT STREET ELBOW, PLATED STEEL 5101440 FITTING, 3/8 HOSE BARB X 1/4NPT, BRASS...
Supplemental Parts List - Electrical Schematic - Charging Circuit IGNITION SWITCH POSITION CIRCUIT MAKE IS3100Z WIRE HARNESS 1. OFF G & M & A 5401150 2. RUN B & L & A 3. START B & L & S GRAY GRAY ORANGE ORANGE...
Supplemental Parts List - Electrical Schematic - Cranking Circuit IGNITION SWITCH POSITION CIRCUIT MAKE IS3100Z WIRE HARNESS 1. OFF G & M & A 5401150 2. RUN B & L & A 3. START B & L & S GRAY GRAY ORANGE ORANGE...
Supplemental Parts List - Electrical Schematic - Ignition Grounding Circuit / Operator Presence IGNITION SWITCH POSITION CIRCUIT MAKE IS3100Z WIRE HARNESS 1. OFF G & M & A 5401150 2. RUN B & L & A 3. START B & L & S GRAY GRAY ORANGE...
Supplemental Parts List - Electrical Schematic - PTO Clutch Circuit IGNITION SWITCH POSITION CIRCUIT MAKE IS3100Z WIRE HARNESS 1. OFF G & M & A 5401150 2. RUN B & L & A 3. START B & L & S GRAY GRAY ORANGE...
Página 32
Supplemental Setup and Operating Instructions and Illustrated Parts Lists for Ferris Zero-Turn Riding Mowers Using Propane Fuel Briggs & Stratton Power Products Group, LLC. 5375 N. Main Street Munnsville, NY 13409-4003 www.ferrisindustries.com...