Assembly [Fig. B] - Imetec SUPERPLATE COMPACT Instrucciones De Uso

USER INSTRUCTIONS

ASSEMBLY [Fig. B]

Attach the telescopic handle (2) to the engine body as shown in the image [Fig. B1]. Adjust the height of the
telescopic handle by pressing the telescopic handle adjusting button (3) [Fig. B2].
Assembling the polishing head (11)
Select the most suitable brushes (12) and install them on the polishing head (11) [Fig. B3].
•
Push the brushes into their housing; you will hear a click when they are locked in position.
•
Attach the engine body to the polishing head (11) making sure that the spring in the polishing head
•
release button (10) is released [Fig. B4].
Assembling the combined brush (13)
Attach the engine body to the combined brush (13) by connecting it to the coupling (13A) [Fig. B5].
ACCESSORIES
Your appliance is equipped with the following accessories:
4-brush set (12) to be used with the polishing head:
Wool felt brushes (12A) : To be used at the end to make wooden fl oors shining
•
Soft brushes (12B)
•
Hard bristle texture brushes (12C) : To be used for wax coating when starting to polish
•
Felt brushes (12D)
•
Note:
Before polishing, lay a small quantity of wax on the fl oor, according to the instructions of the wax
•
manufacturer.
Wait until the wax is dry before polishing.
•
We recommend not to use the hard bristle texture brushes (12C) for delicate fl oor.
•
Combination brush for carpet/bare fl oor (13):
Remove the polishing head (11) by pressing the button (10) located on the back side, pull out the engine
body [Fig. C1] and install the combined brush (13) making sure that the spring clicks into position.
Set the combination brush to the fl oor type with the selector switch (13B) [Fig. C2]:
• Selector switch (13B) on A position (pulling out brush): for hard surfaces.
• Selector switch (13B) on B position (retracted brush): for rugs and carpet.
USE
• Spool the power cord (7) completely by turning the upper rotating winding hook (6) anti-clockwise
[Fig. D1], and insert the plug into the power socket.
For a more comfortable use, connect the power cord (7) to the cord tensioner hook (1A) located at the
•
base of the handle [Fig. D2].
Set the ON/OFF switch (5) to position 1 or 2 to switch on the appliance [Fig. E1]; or position 0 to switch
•
the appliance off.
CAUTION: Using the product with a fully or partially spooled cable may cause the risk of overheating.
: To be used for polishing after fi nishing with the hard bristles
: To be used at the end to make fl oors shining
GB
9