STAMOS S-MIGMA-250.IGBT Manual De Usuario página 8

• Welders powered from a 3-Phase network are delivered without a plug, the plug must be obtained
independently and installation should be assigned to a qualified person.
PLEASE NOTE! THE DEVICE MAY ONLY BE USED UPON CONNECTION TO AN
INSTALLMENT WITH A PROPERLY FUNCTIONING FUSE!
4. OPERATION
S-MIGMA 250.IGBT (2208) WELDING MACHINE
Machine description:
Front view:
7
6
5
4
3
2
1
13
8
9
12
11 10
Inside view:
19
20
MIG torch:
3
1. Nozzle
1
2. Collet
3. MIG welding torch
2
EN
Rear view:
14 15 16 17
18
21
14
Rev. 27.03.2017
No. Function and description
1. ERROR INDICATOR = The indicator lights in the following two situations:
a) If the machine has malfunctioned and cannot be operated.
b) If the cutting device has exceeded the standard working time, the protection mode is initiated
and the machine will stop functioning. This means that the machine is now being cooled in order
to be able to restore the temperature control again after the device has overheated. Therefore,
the machine is stopped. During this process, the red warning light on the front panel lights up. In
this case it is not necessary to unplug the device. The ventilation system may be left on in order to
enhance the cooling of the machine. When the red light goes dark, this means that the temperature
is set to the normal level and the unit can be put back into operation.
2. Power on indicator
3 Wire feed rate adjustment knob
4. MIG voltage adjustment knob
5. TIG / MMA welding current adjustment knob
6. TIG/MIG – MMA switch
7. INCHING – upon pressing this button, the welder starts with the wire feed. The wire will be fed
until the button is released. It is used to feed the wire, e.g. upon the reel replacement.
8. TIG control button connector
9. TIG gas connector
10. „-" Negative output
11. „+" Positive output
12. Welding polarisation change socket.
Connected to the positive pole – MIG welding
Connected to the negative pole – FLUX welding
13. MIG connection socket
14. On/off switch
15. 230V~ CO2 heater socket
16. TIG welding gas connector
17. MIG welding gas connector
18. Power cable
19. Wire reel
20. Wire guide
21. Welding polarisation change cable (MIG/FLUX)
TIG Griff:
1
1. Back cap, long
2
2. Collet
3
3. Torch handle
4
4. Collet inside housing
5
5. Ceramic nozzle
Rev. 27.03.2017
EN
15