Publicidad
Idiomas disponibles
Idiomas disponibles
bEhind ThE ToWEr: position the rail hook into the rail.
onE
on
Pulling outboard on the tower, tighten
crossbar bolt with supplied wrench.
nEXT...
Close bolt cover and turn lever tight.
on opposiTE ToWEr, samE bar:
1033386A - 3/12
it may be
necessary to
loosen the lever
to allow the
hooks to engage
the rail.
onLY
ToWEr
Hold the tower against the rail and
tighten the rail hook using the lever.
Tighten Tower
bolt and close
bolt cover.
ChECk ThE FirsT ToWEr To bE surE
iT is sTiLL TighT againsT ThE raiL.
AS YOU TIGHTEN
THE TOWER BOLT:
• Minimize the gap, until the tower is
tight against the rail.
• Lift the rubber flap to see if the rail is
seated against the tower.
Behind the
tower, make
sure that the rail
hook is hooking
into the rail.
You may need to loosen the lever
Make sure hook
is in the rail.
Keep the pads from
curling at the sides
when positioning the
Hook THe RAiL
on very wide rails.
towers
Tighten hook
into rail.
Publicidad
