Attaching The Src-System™ Pro; Positioning The Speakers - SCHUBERTH SRC SYSTEM PRO Guía De Usario

5. The antenna connector can now be safely stowed
away inside the antenna connector pocket on the
PRO
center of the SRC-System™ .
3.3 ATTACHING THE SRC-SYSTEM
™
1. Make sure to place the speaker cords inside the helmet, and then secure the
SRC-System™ PRO into place.
2. Slide and insert the pin located at the edge of the control panel into its
corresponding indentation on the helmet and close the snap button.
Pin
3. Insert the other pin on the opposite side of the Acoustic Collar into place and
close the second snap button.
4. Push and insert the Acoustic Collar starting from the center area to the back of
the helmet area. Do the same for the remaining parts to secure the Acoustic
Collar into place.
5. Make sure that both snap buttons remain fastened, and that the
microphone boom is located on the inner side of your helmet (between the
SRC-System™ PRO and the inner padding of the helmet).
|
SRCS Pro
8
PRO
Microphone Boom

3.4 POSITIONING THE SPEAKERS

For best audio results, make sure that both of your speakers are placed as closely
as possible just opposite your ears.
The following applies to both sides of the SRC-System™
1. Open the rear red button located under the interior lining that covers the cheek
pads (the button is held by a black ring). Lift the lining slightly.
2. Attach the corresponding oval Velcro pads to the speaker-shaped indentations on
the EPS (expanded polystyrene) and position the speakers on the Velcro pads.
Snap Button
Snap Button
:
PRO