Attaching.the.src-System; Positioning.the.speakers; Positioning.the.microphone; Removing.the.src-System™.From.your.helmet - SCHUBERTH SRC‑SYSTEM S2 Manual De Instrucciones

5.3 ATTACHING THE SRC‑SYSTEM
1.. Make.sure.to.place.the.speaker.and.microphone.cords.inside.the.helmet,.and.
then.secure.the.SRC-System™.into.place.
2.. Push.and.insert.the.SRC-System™.starting.from.the.back.of.the.helmet.area..
Do.the.same.for.the.sides.of.the.SRC-System™.and.then.the.front.of.the.
helmet.area.to.secure.the.SRC-System™.into.place.
5.4 POSITIONING THE SPEAKERS
For.best.audio.results,.make.sure.that.both.of.your.speakers.are.placed.as.closely.
as.possible.just.opposite.your.ears..
The following applies to both sides of the SRC-System™:
1.. Open.the.rear.red.button.located.under.the.interior.lining.that.covers.the.cheek.
pads.(the.button.is.held.by.a.black.ring)..Lift.the.lining.slightly.
2.. Attach.the.corresponding.oval.Velcro.pads.to.the.speaker-shaped.indentations.
on.the.EPS.(expanded.polystyrene).and.position.the.speakers.on.the.Velcro.pads.
32
MAN00097 QG SRC-S2_C3 J 009.indd 32
™ 3.. Close.the.red.button,.making.sure.it.is.still.inside.its.black.holding.ring..
NOTE: Optional speaker pads are provided to boost the speaker volume if needed by
bringing the speakers closer to your ears.
To use, simply place the speaker pad between the Velcro pad in the helmet
indentation and the speaker.
5.5 POSITIONING THE MICROPHONE
Locate.the.spot.on.the.internal.padding.of.the.helmet,.opposite.your.mouth,.
where.the.microphone.will.be.placed.
1.. Peel.the.cover.from.the.adhesive.Velcro.pad.and.place.it.on.the.chosen.
location.opposite.your.mouth.
2.. Attach.the.microphone.to.the.Velcro,.as.shown.in.illustration.
3.. If.there.is.any.excess.microphone.cable,.tuck.it.under.the.cheek.pads.
5.6 REMOVING THE SRC‑SYSTEM™ FROM YOUR HELMET
1.. Detach.both.speakers.and.the.microphone.from.the.Velcro.on.the.helmet..
IMPORTANT: Make sure not to pull on the Antenna connector.
2.. Pull.out.the.Antenna.connector.from.its.pocket.and.carefully.disconnect.it.
3.. Lift.and.push.the.collar's.arch.from.the.front.helmet.area.to.carefully.remove.
the.SRC-System™.from.the.helmet..
7/18/12 5:38 PM