Solutions To Most Frequent Anomalies - Sima COBRA-60 Manual De Instrucciones Original

10. SOLUTIONS TO MOST FREQUENT ANOMALIES

ANOMALIA
The engine will not start
Blade stops turning and will not cut as
it should be
Premature wearing-out of the blade
Premature wearing-out of the
transmission belts
POSIBLE CAUSA
Low oil level alarm is ON
Fuel cock closed
Motor switch is in OFF position
Machine emergency stop switch is
pressed
Insufficient acceleration
belts loosened
Excessive advance
Inadequate blade
Low tension of the motor
Insufficient cooling
Excessive advance
Inadequate blade
Belts are slipping over the pulleys
Pulleys incorrectly tightened
14
SOLUCION
Top up as necessary
Open fuel cock
Turn switch to ON position
Release the button turning it upwards
Accelerate a bit the motor
Tighten the belts
Decrease the advance
Use the adequate blade
material to be cut.
Let a technician check the motor
Make sure sufficient water arrives to
the blade
Decrease the advance
Use the adequate blade
material to be cut.
Tighten the belts
Decrease the advance
Use the adequate blade
material to be cut.
Align pulleys
ENGLISH
for the
for the
for the