Human Touch Novo XT2 Manual De Uso Y Cuidado página 10

take
THE STATUS SCREEN DISPLAYS DURING YOUR MASSAGE, PROVIDING
This handy display not only shows the current status for each of the settings, but allows
you to configure each setting right from this screen. Use the up/down navigation buttons
to toggle through the settings; use the right/left buttons to adjust them.
Speed — The back massage speed (not
configurable when Shiatsu or Audio Sync
Cloud TCH — The Cloud Touch intensity.
Foot SPD — The underfoot roller speed.
Width — The Tap Touch, Percussion, or Shaitsu
horizontal massage range.
3D — The back massage intensity (not
configurable during a deep tissue massage).
The amount of time remaining
in the current massage session
Illustrates the areas currently being massaged
Menu — Displays the main menu.
Auto — Displays the Auto Programs menu.
When an auto program is running, press
to toggle among the auto programs. The
active program displays at the top of the
Cloud — Press to adjust the Cloud Touch
intensity. The selected intensity displays in
the upper left-hand corner of the screen.
Back — Press and hold to recline or
incline the backrest.
Legs Extend — Press and hold to
extend the footrest.
NOTE: During Auto Programs, your
leg length is automatically measured
and the program adjusted accordingly.
If the chair is not in use for three minutes the controller
display automatically shuts down. Press the Stop/Power/
Restore button to resume use. The chair resets all
settings to the default position.
humantouch.com
control
A QUICK REFERENCE FOR THE FOLLOWING INFORMATION
is selected).
status screen.
Indicates if chair is in ZeroG position
Indicates if chair is connected to a
Bluetooth device
The massage techniques currently
in progress
Indicates if heat is on
Stop/Power/Restore — Press this button:
• To power on the remote.
• Select STOP to stop your massage
immediately.
• Select POWER OFF, then select RESTORE
to return the chair to the upright position
before exiting.
Position — Use to move the massage
rollers to the desired position when
enjoying a Zone or Spot massage. See
Using Manual Massage Modes on
page 10 for more information.
Heat — Press to toggle the heat on and
off. When the heat is on, the heat icon
on the screen displays red.
Legs — Press and hold to raise
or lower the footrest.
ZeroG
position the chair in ZeroG mode, raising
your feet above your heart for maximum
spine relief.
Legs Retract — Press and hold
to retract the footrest.
If you use your massage chair for more
than an hour continuously it may overheat
and shut down; this is normal. Allow it to
cool for 30 minutes before resuming use.
8 8
— Press and hold to automatically
®