Desa VN18B, VN18TB Manual De Instalación página 9

INSTALLATION
Continued
INSTALLING HEATER TO WALL
Mounting Bracket
Locate mounting bracket in heater carton. Re-
move mounting bracket from heater carton.
Figure 6 - Mounting Bracket
Removing Front Panel Of Heater
1. Remove the four painted screws, two on
each side of front panel.
2. Pull bottom of front panel forward, then out.
3. Remove any remaining packaging materials.
16"
Min.
Front Panel
Only Insert Mounting
Screws Through Last
Figure 7 - Removing Front Panel Of
Methods For Attaching Mounting Bracket
To Wall
Only use last hole on each end of mounting
bracket to attach bracket to wall. These two
holes are 14" apart from their centers. Attach
mounting bracket to wall in one of two ways:
1. Attaching to wall stud
2. Attaching to wall anchor
Attaching to Wall Stud: This method pro-
vides the strongest hold. Insert mounting
screws through mounting bracket and into
wall studs.
Attaching to Wall Anchor: This method al-
lows you to attach mounting bracket to hollow
walls (wall areas between studs) or to solid
walls (concrete or masonry).
Decide which method better suits your needs.
Either method will provide a secure hold for
the mounting bracket.
121881-01B
14"
Hole On Each End
Floor
Heater
www.desatech.com
Marking Screw Locations
1. Tape mounting bracket to wall where
heater will be located. Make sure mount-
ing bracket is level.
WARNING: Maintain mini-
mum clearances shown in Figure
8. If you can, provide greater
clearances from floor and join-
ing wall.
2. Mark screw locations on wall (see Figure 8).
Note: Only mark last hole on each end of
mounting bracket. Insert mounting screws
through these holes only.
3. Remove tape and mounting bracket from
wall.
Screw
25 / "
3
4
Optional
19 / "
3
4
Min.
Figure 8 - Mounting Bracket Clearances
Attaching Mounting Bracket To Wall
Note: Wall anchors, mounting screws and
spacers are in hardware package. The hard-
ware package is provided with heater.
12"
14"
Min.
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
3 Plaque Heater
16"
14"
Min.
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
4 and 5 Plaque Heaters
25 / "
3
4
Optional
19 / "
3
4
Min.
25 / "
3
4
Optional
19 / "
3
4
Min.
9
1
M