Epson TM-U950 Manual Del Usuario página 7

1. Make sure the leading edge of
the paper is straight.
2. Turn on the printer and open
the printer cover.
3. Insert paper rolls on both the
receipt and journal sides of
the printer, as shown in
illustration
is on the right in this
illustration.)
4. For each roll, insert the tip of the
paper into the paper inlet and
push it in until it is automatically
detected and fed into the printer.
See illustration
5. Tear off the receipt paper on the
cutter. If the paper was not fed far
enough, press the RECEIPT FEED
button to feed additional paper.

6. Insert the tip of the journal paper
into the groove in the take-up spool
and rotate the spool two or three
times to secure the paper. See
illustration
was fed, press JOURNAL/SLIP FEED
to feed more.
7. Install the take-up spool and close the
printer cover.
8. To remove the journal paper roll, first
lift the take-up spool and cut the paper.
Then remove the take-up spool. See
illustration
9. For either a journal or receipt paper roll,
next press the release lever (marked
PRESS) on the appropriate side of the
printer, pull out the paper, and remove
the roll.
. (The journal roll
3
.
4
. If not enough paper
5
6 .
3
4
5
✄
6
TM-U950 User's Manual 5
English
✔
Correct
✖
Wrong