Fantech FQ Serie Manual De Instrucciones página 2

Hanger bar
Hanger bar
Wire box cover
Power supply
Housing
protective tube
Insert Suspension bracket
Insert Suspension bracket
Power supply
Figure 3-1
Figure 3-1
protective tube
Wire box
Figure 3-2
Figure 3-2
Ceiling
Installation
Joists
The unit should only be installed in a ceiling. The size of joists should be at least
2" wide and 4" high . The space between two joists should be 16". From the above
Wire box
surface of the suspended ceiling there should be minimum 9" distance to the roof.
Ceiling
(Figure 2) Select the suspension brackets as shown in (Figure 3)
Joists
Spacing A on center joist
16 inches
Spacing A on center joist
24 inches
16 inches
24 inches
1. Remove the grille by gently squeezing the wire springs and extracting
them from the slots in the housing.
2. Remove the wire box cover and install the 3 brackets on the fan housing.
(Figure. 3-1, Figure. 3-2).
2
Fan outlet
Ceiling joist
Housing
Fan outlet
Wire box cover
Ceiling joist
Hanger bar
Wire box cover
Figure 3
A
Insert Suspension bracket
A
Figure 3-1
Insert Suspension bracket
Figure 3-2
Figure 3-1
Figure 3-2
Figure 3-1
Figure 3-2
Figure 2
Hanger bar
3. To install the housing in the ceiling, position it between the joists and
extend the brackets to the adjacent joists.. Mark the screw locations (at
the top of the keyhole on each bracket) on the joists.
NOTE:
The bottom edge of the housing should be flush with the bottom of the joist.
(Figure 4)
4. Remove the housing and drive the screws part way into the joists at the
marked locations. (Figure 5)
5. Mount the housing using the screws in the joists and then secure them
tightly. Make all the electrical connections in the wire box, per the wiring
diagram, and attach the wire box cover. Attach the discharge duct tightly
onto the fan outlet.
NOTE:
In order for the fan to operate efficiently, keep the discharge duct as
straight as possible. (Figure 6)
6. To complete the installation, install the lamps (if applicable) and mount the grille.
16 inches
24 inches
Plug-in
Plug-in
Figure 3-1
Figure 3-2
Figure 4
Figure 5
Plug-in
Figure 6