Publicidad
Step 5
NOTE: Before beginning this step, separate the BLACK
å
2-1/4" FLAT HEAD SCREWS (TT) and BLACK 1-7/8" FLAT
HEAD SCREWS (UU). Do not confuse these SCREWS.
Fasten the RIGHT MOLDING (V) to the RIGHT END (A).
å
Use two BLACK 2-1/4" FLAT HEAD SCREWS (TT).
Fasten the UPPER SHELF (E) to the RIGHT END (A).
å
Tighten two TWIST-LOCK® FASTENERS.
Insert three METAL PINS (RR) into the UPRIGHT (C).
å
Insert the METAL PINS (RR) in one end of the UPRIGHT (C)
å
into the holes in the UPPER SHELF (E).
BLACK 2-1/4" FLAT HEAD SCREW
(2 used in this step)
U
Long edge with
TWIST-LOCK®
FASTENERS
Page 10
TT
V
E
i t h
e w
K ®
f a c
L O C
S u r
I S T -
E R S
T W
T E N
F A S
RR
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking
the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight
as possible.
A
C
Edge with one
METAL PIN
8070-297
Caution
®
FASTENER
Finished edge
www.sauder.com/services
Dowel end
Publicidad
