Publicidad
Step 17
Push the RUBBER SLEEVES (SS) over the remaining METAL PINS (RR). Insert the METAL PINS into the hole locations of
å
your choice in the RIGHT END (A) and UPRIGHT (C). Set the ADJUSTABLE SHELVES (Q) onto the METAL PINS.
To insert the SLIDING SHELF (P) into your unit, line up the EXTENSION SLIDES (AA) on the KEYBOARD UPRIGHTS with
å
the EXTENSION RAILS (Z) on the unit. Push the SLIDING SHELF into the unit until the SHELF is fully inserted. The SHELF
will push in hard until it is all the way in, then it will slide in and out easier.
To insert the KEYBOARD SHELF (M) into the unit, tip the front of the SHELF down and drop the rollers on the SHELF
å
behind the rollers on the unit. Lift the front of the SHELF up and slide it into the unit. Repeat this process to insert the
PRINTER SHELF (I).
NOTE: Please read the back pages of the instruction booklet for important safety information.
å
This completes assembly. Clean with your favorite furniture polish or a damp cloth. Wipe dry.
å
And to celebrate, why not share your success story?
Page 22
15 lbs.
40 lbs.
A
C
60 lbs.
15 lbs.
P
25 lbs.
M
40 lbs.
I
60 lbs.
8070-297
5 lbs. each
Q
RR
(8 used)
SS
www.sauder.com/services
Publicidad
