Sauder 8070-297 Manual Del Usuario página 8

Step 3
Separate the EXTENSION SLIDES (AA) from the EXTENSION
å
RAILS (Z) as shown in the enlarged diagram below. Be
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (Z) to the ENDS (A and B). Use
å
four GOLD 5/16" FLAT HEAD SCREWS (BBB).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the inner cartridge
of the EXTENSION RAIL in to fi nd the other hole that lines up
with the hole in the END. Turn a SCREW into this hole.
Use this hole.
Open end
Page 8
AA
Push the metal release lever in and pull the SLIDE from the RAIL.
Finished edge
Z
B
8070-297
Z
A
Finished edge
Remember:
Righty tighty.
Lefty loosey.
Z
BBB
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
Open end
www.sauder.com/services