Sauder 8070-297 Manual Del Usuario página 14

Step 9
Fasten four ANGLE BRACKETS (GG) to the ENDS (A and B). Use four BLACK 9/16" LARGE HEAD SCREWS (ZZ).
å
NOTE: Be sure the edges of the ANGLE BRACKETS are even with the edges of the ENDS.
å
Fasten the END MOLDINGS (Y) to the ENDS (A and B). Use four BLACK 9/16" LARGE HEAD SCREWS (ZZ) through the
å
ANGLE BRACKETS on the ENDS and into the END MOLDINGS.
NOTE: The END MOLDINGS should overhang the inside of each END. There are no pre-drilled holes in the END MOLDINGS.
å
The SCREWS will tighten into the grooves.
Fasten the VALANCE (T) to the FRONT MOLDING (U) and END MOLDINGS (Y). Use four BLACK 9/16" LARGE HEAD
å
SCREWS (ZZ) through the ANGLE BRACKETS and TIE PLATES on the VALANCE and into the holes in the FRONT
MOLDING and grooves in the END MOLDINGS.
NOTE: The VALANCE should fi t evenly between the END MOLDINGS. If needed, the VALANCE can be adjusted. Loosen the
å
SCREWS that fasten the VALANCE to the FRONT MOLDING, make needed adjustments, and tighten the SCREWS.
(4 used)
GG
Y
BLACK 9/16" LARGE HEAD SCREW
(12 used in this step)
Page 14
GG
Y
U
T
B
ZZ
A
8070-297
The SCREWS will
tighten into this groove
www.sauder.com/services