Publicidad
Step 20
Carefully turn your unit over onto its front edges. Unfold
å
the LARGE BACK (O) and lay it over your unit.
Tighten the TWIST-LOCK® FASTENERS in the
å
MODESTY PANEL (J).
Make equal margins along all four edges of the LARGE
å
BACK (O). Push on opposite corners of your unit if needed
to make it "square".
Fasten the LARGE BACK (O) to your unit using NAILS (SSS).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the UPRIGHT and SHELVES.
Repeat this step to fasten the SMALL BACK (P).
å
NOTE: Perforated cut-out lines have been provided
å
for access through the BACKS. Carefully cut out the
rectangle in the SMALL BACK for proper ventilation of
your CPU.
Notched edge
www.sauder.com/services
These holes must line up over
the UPRIGHTS and SHELVES.
O
P
158034
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
SSS
NAIL
(73 used in this step)
Tighten these two
TWIST-LOCK® FASTENERS.
J
Page 25
Publicidad
