Publicidad
Step 24
1
D87
Groove
Insert the DRAWER SIDES (D88 and D87) at an angle
å
into the slot at each end of the DRAWER FRONT (U).
3
Fasten the DRAWER BACK (D78) to the DRAWER SIDES (D87 and D88). Use four BLACK 1-9/16" FLAT
å
HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D708) inserts into the groove of the DRAWER BACK (D78).
å
Repeat this step for the small drawers.
å
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D88
U
D78
D87
D708
VIEW THE T-LOCK BOX VIDEO
2
D87
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D708) into the grooves in the
å
DRAWER SIDES (D87 and D88) and DRAWER FRONT (U).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D88
158034
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n
fi n
s u
i s h
r f a
e d
c e
D708
D88
U
30S
(12 used in this step)
Page 29
Publicidad
