Throttle Curves; Pitch Curves - Spectrum DX8 Guía De Inicio Rápida

EN
To Select D/R and Expo Values
Confirm you have chosen the desired channel and selected the switch position.
Rotate the roller to highlight the D/R or Expo values then press the roller to
access the values. When you center the corresponding channel' s control stick,
both values are highlighted. Moving the control stick to its endpoint causes one
value to be highlighted. This allows the D/R or Expo value in that direction only to
be changed. With the desired value selected rotate the roller to select the desired
D/R or Expo value. Afterwards, press the roller to accept the values.
StEP #8

THROTTlE CURVES

The DX8 features a five-point throttle curve with individual throttle curves for each
flight mode. A graphic display at the left side of the screen aids in adjusting the
curves. Also, an Expo function is available that smoothes out the curve.
To Program Throttle Curves
In the Function List rotate the roller to highlight Throttle Curve. Press the roller to
access that screen.
Highlight the desired flight mode at the top of the screen then press the roller to
select. The selected flight mode will darken confirming your selection.
N= Normal
1= Stunt 1
2= Stunt 2
H= hold
Adjusting the Curve
Move the flight mode switch in the position you wish to adjust. Rotate the roller
to highlight one of the five available throttle curve values (Low, 25%, 50%, 75%,
High). Press the roller to access that value. Rotate the roller to adjust the selected
point to the desired output position and press the roller to accept the value. Note
the position on the graph at the left of the screen.
Repeat this for all desired points.
14
To Activate the Expo function
Rotate the roller to highlight EXPo. Press the roller to toggle between the activate
and inhibit settings.
StEP #9

PITCH CURVES

The DX8 features a five-point Pitch curve. You can assign the available four
individual pitch curves to flight modes. A graphic display at the left side of the
screen aids in adjusting pitch curves. Expo is available and smoothes out the
curve.
To Program Pitch Curves
In Function List rotate the roller to highlight Pitch Curve then press the roller to
accept the function.
Selecting a flight Mode
Highlight the desired flight mode at the top of the screen. Press the roller to
select. The selected flight mode will darken confirming the selection.
N= Normal
1= Stunt 1
2= Stunt 2
H= hold
Adjusting the Curve
Placing the flight mode switch in the right position you wish to adjust does not
allow changes to that position. Highlighting it with the scroll wheel allows changes
to be made. Rotate the roller to highlight one of the five available throttle curve
values (Low, 25%, 50%,75%, High). Press the roller to access that value. Rotate
the roller to select the flight mode position you wish to program and press the
roller to accept the flight mode. Note the position on the graph at the left of the
screen.
Repeat this for all desired points.
SPEKTRUM DX8 • PROGRAMMING GUIDE