Gyro; Governor - Spectrum DX8 Guía De Inicio Rápida

To Activate the Expo function
Highlight EXPo then press the roller to toggle between the activate and inhibit
settings.
StEP #10

GyRO

The Gyro function allows you to program the adjustment of up to four gyro gain
values from a variety of switches including the flight mode switch. You can select
the channel the gyro gain is on.
To Activate the Gyro Gain function
In the Function List rotate the roller to highlight Gyro. Press the roller to access
that screen.
To Select a Switch
To activate the Gyro function, highlight Inhibit, then press the roller to access the
switch function. Rotate the roller to access the desired gyro control switch. Press
the roller to accept the gyro control switch and access the Gyro gain screen
Assigning a Channel
You can assign the receiver channel the gyro gain is plugged into in this screen.
The governor and the gyro must use two different channels. If the governor
function uses a channel, it will not appear in the gyro list.
Highlight Ch: (channel) then press the roller to access the gyro channel function.
Select the desired channel to plug the gyro gain into and press the roller to accept
the switch. Normally the Gear channel is used.
SPEKTRUM DX8 • PROGRAMMING GUIDE
Adjusting the Rate Values
Rotate the roller to select the desired gain value then press the roller to select the
gain value.
Note: The displayed value is the corrected gyro value. 0% represents 1.500ms or
oFF with most gyros.
Repeat this for all desired Gain values.
StEP #11

GOVERNOR

The Governor function adjusts engine rpm when using a Governor or throttle
limiter. You can program the selection of up to four governor values from a variety
of switches including the flight mode switch. Also you can select the channel the
governor controls.
In the Function List rotate the roller to highlight Governor then press the roller to
access that screen.
To Select a Switch
The Governor function defaults to Inhibit. To activate the Governor function, rotate
the roller to highlight Inhibit; then, press the roller to select the desired control
switch by rotating the roller. Afterwards, press the roller to accept the switch
choice and enter the governor screen.
Assigning a Channel- (Output)
In this screen you can assign the receiver channel the Governor is plugged into.
The governor and the gyro must use two different channels. If the gyro function
uses a channel, it will not appear in the governor list.
Rotate the roller to highlight Ch: (channel) then press the roller to access that
function. Select the desired channel to plug the governor in to and press the roller
to accept the channel. Normally Aux 2 is used.
EN
15