Dual Rates And Exponential - Spectrum DX8 Guía De Inicio Rápida

Rotate the roller to highlight the value at the bottom of the screen then press the
roller to access the Sub-Trim Value. Rotate the roller to adjust the Sub-Trim value for
the selected channel. Then press the roller to accept.
To Access the Travel function
In the Reversing screen rotate the roller to highlight Reverse then press the roller.
Now rotate the roller until Travel appears. Press the roller to enter Travel function.
Highlight the channel then press the roller to access. Rotate the roller to select
the channel to adjust then press the roller to accept that channel.
Highlight the values at the bottom of the screen. When you center the
corresponding stick both values are highlighted and adjusted simultaneously.
Moving the stick or switch in the desired position allows you to independently
adjust that direction of travel. With the desired value (s) highlighted rotate the
roller to adjust the travel value for the selected channel. Then press the roller to
accept the value.
StEP #6

DUAl RATES AND EXPONENTIAl

The Dual Rate and Exponential functions allow you to program up to three
control rates and select them independently or with a single switch. Dual Rates
and exponentials are available on the aileron, elevator and rudder channels.
Positive expo values reduce control sensitivity around center with no effect on
maximum travel. We recommend using positive values. Negative exponential
values increase sensitivity around neutral and are seldom used.
To Access the D/R and Expo function
In the Function List rotate the roller to highlight D/R and Expo. Then press the
roller to access the D/R and Expo screen.
SPEKTRUM DX8 • PROGRAMMING GUIDE
To Select a Channel
Rotate the roller to highlight the channel function then press the roller to select
the function. Next rotate the roller to select the aileron, elevator or rudder
channel. Then press the roller to accept that channel.
To Select a Switch
Rotate the roller to highlight SW (switch) at the bottom of the screen then press
the roller to access the switch options. Rotate the roller to select the desired
switch then press the roller to activate that switch.
Note: By assigning multiple channels to the same switch, you can use a single
switch to affect the dual and exponential rates of multiple channels.
To Select a Switch Position to Adjust
Move the switch displayed at the bottom of the screen to change the Pos to
one of its three positions. When you make D/R or Expo adjustments, the values
assign and are automatically active when the switch is in that position (Pos 0,
1or 2).
To Select D/R and Expo Values
Confirm you have chosen the desired channel and selected the switch position.
Rotate the roller to highlight the D/R or Expo values then press the roller to
access that value. When you center the corresponding channel' s control stick,
both values are highlighted. Moving the control stick to its endpoint causes one
value to be highlighted. This allows the D/R or Expo value in that direction only
to be changed. With the desired value selected, rotate the roller to select the
desired D/R or Expo value.
EN
7 7