Spectrum DX8 Guía De Inicio Rápida página 4

EN
8. Programming the Transmitter
at this point you're ready to program the transmitter. Turn on the transmitter then the receiver. check that the
direction of each channel is correct. use the servo-reversing menu to change the servo directions if necessary
(see page 6 and 7 in the dX8 Programming guide for details on servo reversing). adjust the Travel adjust
and any other programming functions necessary for the type of aircraft you are programming. The following
programming guide is included to help you through basic programming.
9. Re-bind the System
once your model is programmed, you must re-bind the system to the true low throttle position. if the signal is
lost, the throttle servo will drive to its preset position chosen during binding (normally low-throttle).
10. Range Check
a. With the system powered and the model restrained from flyaway, stand 30 paces (approximately 90
feet/30 meters) away from the model.
B. Face the model with the transmitter in your normal flying position. Place the transmitter in the range
Test screen and press the Trainer button on the top of the transmitter. This causes reduced power
output from the transmitter.
c. You should have total control of the model with the trainer button depressed at 30 paces
(90 feet/28 meters).
d. if control issues exist, contact the appropriate horizon hobby Product support office or go to
horizonhobby.com to find a local spektrum distributor in your country of service.
4
30 paces (90 feet/28 meters)
SPEKTRUM DX8 • PROGRAMMING GUIDE