Spectrum DX8 Guía De Inicio Rápida página 17

StEP #14
SETTING UP A TIMER ACTIVATED by
THROTTlE POSITION
You can program the timer to start when the throttle is raised above a
preprogrammed position.
Note: To reset the timer, from the main screen press the Clear button.
To Access the Timer Screen
In Function List rotate the roller to highlight Timer. Press the roller to access the
Timer screen.
To Select the Timer Mode- Inhibit, Count Down or Stop Watch
Rotate the roller to highlight Mode then press the roller to access the Mode
function. Rotate the roller to select Inhibit, Count Down or Stop Watch. When the
desired timer mode is selected, press the roller to accept the mode type.
to Program a time
Rotate the roller to highlight Time then press the roller to access the Time
function. You can highlight the seconds or minutes. Press the roller to access
minutes or second. Rotate the roller to select the desired time. Press the roller
to accept.
To Select the Timer to Activate on Throttle Up
Rotate the roller to highlight Start then press the roller to access the Start
function. Select Throttle or Throttle 1-Time then press the roller.
Throttle 1-time - The timer starts when you exceed the programmed throttle
position. It continues regardless of the throttle position.
Throttle - The timer starts when you go above the programmed throttle position.
Anytime you lower the throttle below the programmed position, the timer pauses
then continues when you raise the throttle above that position. This is useful for
flying electric models where the motor runtime not the flight time is important.
SPEKTRUM DX8 • PROGRAMMING GUIDE
Pos appears below Start in the Timer screen. This value is the stick position
where the throttle activates the timer. Rotate the roller to highlight Stick. Press
the roller to access the Stick values. The value is adjustable from 0 to 100% and
correlates to the actual throttle stick position. Rotate the roller to select the desired
Stick value then press the roller to accept
To select the warning type, highlight Tone then press the roller. Rotate the roller to
select Inhibit, Tone, Vibe or Tone and Vibe. Press the roller to accept the setting.
EN
17