Troubleshooting - Buffalo DM079 Manual De Instrucciones

Cleaning & maintenance
Always turn off the appliance and disconnect from power supply before cleaning.
Warm soapy water is recommended for cleaning. Cleaning agents may cause damage or leave harmful residues
when used for a prolonged period on stainless steel.
A BUFFALO dealer or qualified technician should carry out repairs if required.
Trouble Shooting
Fault
The unit is not working
Technical Specification
Model Voltage
DM079 230v 50Hz
Electrical Wiring
This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 3 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being
required they must be readily accessible.
Probable Cause
The Unit is not switched on
Bulb has blown
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
The door is not shut correctly
Power Dimensions
h x w x d mm
20w 600mm x 510mm x 150 mm
Check the unit is plugged in
correctly and switched on
Replace bulb (Bulb must have a
light wave length of 253.7nm –
please contact your retailer)
Call BUFFALO agent or qualified
technician
Replace the plug fuse
Check Power Supply
Call BUFFALO agent or qualified
technician
Shut the door
Weight
(kg)
7
4
Action