Publicidad
Idiomas disponibles
Idiomas disponibles
Remove end cap.
Press in the tabs on either side
and pull end cap to remove.
Remove long knob and t-bolt.
Unscrew the knob to
separate from t-bolt.
Slide clamp back on.
For installation on
round bars USE ONLY
UPPER NOTCH with
IF YOU NEED FURTHER TECHNICAL ASSISTANCE OR REPLACEMENT PARTS:
Please contact your dealer or call us at (888) 925-4621 Monday through Friday, 7:00
1033590-2/6
Replace the clamp and
wheeltray onto bike mount.
bail adapter!
Slide off clamp.
Install t-bolt adapter and t-bolt.
• Insert t-bolt adapter through hole in top of
clamp into lower hole of clamp as shown.
• Insert t-bolt through clamp and t-bolt
adapter pressing firmly to snap t-bolt into
t-bolt adapter.
NOTE: T-bolt adapter must
be orientated as shown.
Reinstall end cap.
Replace the end cap.
Attach short knob.
• Install bail adapter onto
bail as shown.
• Install short knob once
rear clamp is in place
around crossbar.
Slide off the wheeltray and clamp.
Fully tighten down clamp. Verify
that your installation is complete.
.
. to 5:00
a
m
.
. PST.
p
m
Publicidad
