Installing The Battery; Charging The Battery - Motorola V3 GSM Manual Del Usuario

Installing the Battery

1.
2.
3. 4.

Charging the Battery

New batteries are shipped partially charged. Before you
can use your phone, you need to install and charge the
battery as described below. Some batteries perform best
after several full charge/discharge cycles.
Tip: The angle connector provided with your phone makes
it easier for you to use the phone with an attached battery
charger or phone accessory.
Action
1 Insert the travel
charger plug into
the detachable
angle connector
as shown.
2 Insert the angle
connector plug
into the USB
connector port on
your phone.
3 Plug the other end of the travel charger into the
appropriate electrical outlet.
Note: It may take up to 10 seconds for your
phone to provide a visible or audible indication
that the battery is charging.
4 When your phone indicates Charge Complete,
remove the travel charger and angle connector.
Note: You can safely leave the travel charger connected to
the phone after charging is complete. This will not damage
the battery.
11 12