Assembly & Operation - Worx Nitro WG751 Manual De Instrucciones

ASSEMBLY & OPERATION
NOTE: Read instruction handbook before
operation this machine.
ASSEMBLY & OPERATION
Action
ASSEMBLY
Assembling the handle bar
Adjustment Handle's height
Assembling the grass collection bag
Assembling the grass collection bag to
the lawn mower
NOTE: Depress the grass collection
bag slightly to ensure that it is
completely installed.
NOTE: Take the mulching insert out
of the lawn mower before fitting the
grass collection bag.
Removing/emptying grass collection
bag
WARNING! Always check the
safety flap close the discharge
outlet before using. Never lift the
safety flap when the lawn mower is
being used without fitted grass
collection bag.
Installing side-discharge chute
Installing mulching insert
Removing /fitting the battery pack
NOTE: This machine will only run
when 2 batteries are installed. It is
recommended to use the same two
batteries and charge the two batteries
at the same time.
When you use two batteries with
different power, the machine will
only run to the lower common
denominator.
Checking the battery charge
condition
NOTE: Fig. H1 only applies for the
battery pack with battery indicator
light.
Charging the battery pack
NOTE: The batteries are shipped
uncharged. Each battery must be fully
charged before the first mow.
Always fully charge the two batteries
at same time. More details can be
found in charger's manual.
3-in-1 Cordless Lawn Mower
OPERATION
Power indicator light
See details in BATTERY STATUS part
IMPORTANT:
When only one light is illuminated,
Figure
your battery is overly discharged,
even though the machine may still
be capable to work. Continuing
to operate your machine with
See Fig. A1
the battery in this discharged
See Fig. A2
condition may reduce the life and
performance of your battery.
See Fig. B
When no light is illuminated,
at least one battery is not fully
installed or battery may be
defective, please double check
the batteries are fully seated into
See Fig. C1,
position.
C2, C3
Starting and Stopping
Adjusting the cutting height
WARNING! Stop, release switch
lever and wait until the motor
stops before adjusting height. The
blades continue to rotate after the
See Fig. D
machine is switched off, a rotating
blade can cause injury. Do not touch
rotating blades.
Storage
See Fig. E1
E2
BATTERY STATUS (See Fig. J)
• Before starting or after use, press the button
See Fig. F
beside the power indicator light on the machine to
check the battery capacity.
• During operation, the battery capacity will be
indicated automatically by the battery power
indicator. The indicator constantly senses and
displays the battery condition as follows.
See Fig. G1,
• For the machine with 2 battery packs with different
G2
power, the power indicator light displays the battery
condition with the lower one of the two batteries.
Battery power
indicator status
Five green lights
(
See Fig. H1
illuminated.
Two, three or four
green lights are
illuminated.
See Fig. H2
Only one green
light (
illuminated.
Battery condition
The two batteries are in a
) are
highly charged condition.
The two batteries have a
remaining charge. The more
lights are illuminated, the
more battery capacity.
The battery level of at least
one battery pack is very low.
) is
Please check and charge the
battery pack.
See Fig. J
See Fig. K1,
K2, K3
See Fig L
15
See Fig. M1,
M2
EN