Worx Nitro WG751 Manual De Instrucciones página 17

NOTE:
1. Be sure the mower is turned off and remove the
key.
2. Place the mower in stand up storage mode.
BLADE BALANCING (See Fig. O)
Check balance of blade by placing center hole in
blade O-1 over a nail or screwdriver shank O-2,
clamped horizontally in a vise O-3. If either end of
the blade rotates downward, file that end. Blade is
properly balanced when neither end drops.
BLADE MAINTENANCE (See Fig. P1, P2)
Replace your metal Blade after 50 hours mowing
or 2 years, which ever is the sooner-regardless of
condition.
Follow these procedures to remove and replace the
Blade. You will need garden gloves (not provided)
and a spanner wrench (not provided) to remove the
Blade. Hold the Blade and unscrew the Blade Bolt
counter-clockwise using a spanner wrench, and then
remove the Blade.
To re-assemble, position the Blade with the cutting
edges towards the ground. Then securely tighten the
Blade Bolt.
STORAGE (SEE FIG. M1,
M2)
Stop the mower and always remove the Safety Key.
Clean the exterior of the machine thoroughly using
a soft brush and cloth. Do not use water, solvents or
polishes. Remove all grass and debris, especially from
the ventilation slots.
Turn the machine on its side and clean the blade area. If
grass cuttings are compacted in the blade area, remove
with a wooden or plastic implement.
Store the machine in a dry place. Do not place other
objects on top of the machine.
To aid storage, release the Handle knobs, and rotate or
fold the Upper Handle.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage
o
of tool and battery is 0 C-45
The recommended ambient temperature range for the
charging system during charging is 0
104 o F).
3-in-1 Cordless Lawn Mower
o o o
C (32 F-113 F).
o o o
C-40 C (32 F-
17
EN