Taurus ALPATEC AC205RVKT Manual Del Usuario página 21

WATER TANK FULL PROTECTION:
- When the water level in the bottom water plate
is above the warning level, the unit will alert
automatically a.
- -Please discharge water in the machine accord-
ing to chapter "water drainage".
WATER DRAINAGE:
- When the inner water tank is full, its indicator
will flash on the screen.
- The appliance enters into standby mode.
- Pull out the plug to drain out water, power off
the machine and restart it , the machine will
runs normally .
- -This model have self evaporative function, un-
der cooling mode, please do not use continue
drainage to get better cooling effect.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off, using the on/off switch.
- Unplug the appliance from the mains.
CLEANING
- Wipe the appliance with a damp cloth impreg-
nated with a few drops of detergent. Do not use
solvents or products with an acidic or basic pH
factor such as bleach or abrasive products to
clean the apparatus.
- Do not immerse the connector in water or other
liquid or place it under the tap. If the appliance
is not maintained in good condition
- Cleaning, its surface can be degraded and inex-
orably affect the life of the appliance and lead to
a dangerous situation.
If any fault is detected, refer to the following table:
Problem
Product is not working
Seems device is not
working
Devide noise too loud
Compressor is not
working
Causes
No llega corriente.
Indicador de llenado de agua
iluminado
Windows or doors are open
Dirty filter
Air inlet or outlet are block
Room temperature is lower
than the programated
Device is not in a flat surface
Overheat protection is activa-
ted
CLEANING THE AIR FILTER:
- Clean the air filters every 2 weeks. If the air
filter is blocked with dust, its effectiveness will
be reduced.
- Washing the air filters by submerging them
- Carefully in warm water with a neutral deter-
gent, rinse them off and let them dry completely
in a shady place.
- Install the filters carefully after having them
cleaned.
AFTER PERIODIC MAINTENANCE:
- Switch off the appliance and remove the plug.
- Separate the exhaust pipe from the air and
store it carefully.
- Put the appliance in a dry place.
- Remove the batteries from the remote control
and store them carefully.
ANOMALIES AND REPAIR
- In the event of a fault, take the appliance to an
authorized service center. Do not attempt to dis-
assemble or repair it as there may be danger.
- Any person who is involved with working on or
breaking into a refrigerant circuit should hold
a current valid certificate from an industry-ac-
credited assessment authority, which authorizes
their competence to handle refrigerants safely
in accordance with an industry recognized
assessment specification.
- Servicing shall only be performed as recom-
mended by the equipment manufacturer. Main-
tenance and repair requiring the assistance
of other skilled personnel shall be carried out
under the supervision of the person competent
in the use of flammable refrigerants.
Solutions
Switch on device
Empty water tank
Start device after empty water tank
Close courtains
Close windows
Clean or change air filter
Clean container
Change temperature setting
Change device in a flat surface
Switch on device after 3 minutes, when
temperature is lower