Kohler K-10103 Guia De Instalacion página 12

Troubleshooting (cont.)
Symptoms Probable
Causes
L. Hose is
M. The
Low flow. A. Supply
2.
B. The filters
C. The
3. Constant A. The
water flow.
B. The
C. The
1056542-2-B
Recommended Action
L. Check the hoses to make
kinked. certain they are not kinked. If
a hose is kinked, disconnect the
hose, straighten, then reconnect.
M. Remove the valve cover and
solenoid solenoid. Replace the solenoid
as needed. Refer to the "Test
does not
work. and Service the Solenoid"
section of the Homeowners
Guide.
A. Check filtration systems for
pressure is blockage. Check incoming
low. water pressure. Pressure should
be at least 20 psi (137 kPa).
B. Refer to the "Service the Filters"
are section of the Homeowners
plugged. Guide.
C. Remove the aerator and clean.
aerator is For calcium/mineral deposits,
plugged. soak the plastic insert in a 50:50
mix of water and vinegar. Soak
only the plastic insert.
A. Turn off the water supply and
diaphragm purge the faucet. Remove the
seal is cover and check the diaphragm
dirty or and surrounding area for
damaged. debris. Clean out any debris. If
the diaphragm is damaged,
order a replacement. Refer to
the "Service the Diaphragm"
section of the Homeowners
Guide.
B. Remove the valve cover and
battery life replace the battery. The spout
has requires a standard 2CR5 6 V
expired. lithium battery. This item is not
available from Kohler Co., but
can be purchased at retail
stores.
C. Remove the valve cover and
solenoid is solenoid. Check the solenoid
plugged. holes for debris.
12 Kohler Co.