To Assemble The Transport Wheels (Accessory); Operation; Before You Operate The Product; To Fill Fuel - Husqvarna GX560 Manual De Usuario

To assemble the transport wheels
(accessory)
1. Put the hook attached to the handle (A) through the
center slot (B), in the direction of the arrow (C).
D
2. Turn the handle clockwise 90° to put the ends of the
lower handle between the brackets (D) on the cutting
cover.
3. Put the bushing (A) through the brackets and the
ends of the lower handle.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.

Before you operate the product

1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Examine the cutting equipment to make sure that it
is correctly attached and adjusted. See
the cutting equipment on page 10 .
3. Fill the fuel tank. See
4. Fill the oil tank and do a check of the oil level. See
To fill and change the engine oil on page 11 .

To fill fuel

If available, use low-emission/alkylate gasoline. If low-
emission/alkylate gasoline is not available, use good
461 - 006 - 25.01.2019
90°
A
B
C
A
To examine
To fill fuel on page 7 .
4. Attach the wheel frame (A) to the cutting deck with
the screws (B), washers (C, D) and locknuts (E).
5. Put the lower extension tubes into the top extension
tubes.
6. Put the clevis pins (A) through the extension tubes
and lock with the lockpins (B).

Operation

quality unleaded gasoline or leaded gasoline. Use
gasoline with an octane number of 90 RON out of North
America (87 AKI in North America) or higher, and with a
maximum of 10% ethanol (E10).
CAUTION: Do not use gasoline with an
octane number less than 90 RON out of
North America (87 AKI in North America).
This can cause damage to the product.
1. Open the fuel tank cap slowly to release the
pressure.
2. Fill slowly with a fuel can. If you spill fuel, remove it
with a cloth and let remaining fuel dry off.
3. Clean the area around the fuel tank cap.
4. Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
5. Move the product a minimum of 3 m (10 ft) from the
position where you filled the tank, before a start.
D
E
C
B
A
B
A
7