3M itarus Manual Del Usuario página 58

An This respirator meets the requirements of
AS/NZS 1716:2012 and should be used to protect the
wearer against gas / vapours and particulate
contaminants only.
^ Particular attention should be given to warning
statements where indicated.
^ WARNINGS
contaminants. Failure to follow all instructions on
Always be sure that the complete product is:
- Suitable for the application;
- Fitted correctly;
- Worn during all periods of exposure;
- Replaced when necessary.
refer to all information supplied or contact an
USE LIMITATIONS
complete product in accordance with applicable Health
and Safety standards/guidance.
from natural rubber latex.
their own limits on oxygen deficiency. Seek advice if in
doubt).
atmospheric contaminants/concentrations which have
poor warning properties or are unknown or immediately
contaminants/concentrations which generate high heats
of reaction with chemical filters.
flames or liquid metal droplets.
resistance occurs.
c) You smell or taste contaminants or irritation occurs.
damaged or breathing resistance becomes excessive.
FITTING INSTRUCTIONS
^
product is worn.
1. Assemble/adjust head cradle by feeding the
perforated strip through the buckle and pressing down
on the stud at the required length. Repeat for the
second strip.
head harness over the crown of the head.
harness for a comfortable fit and repeat step 2.
the back of the neck and hook the straps together.
ends of the straps to achieve a comfortable and secure
fit. Tighten the bottom straps in a similar manner. (Strap
tension may be decreased by pushing out on the back
side of the buckles)
in place
FIT CHECK
7. Perform a Positive Pressure Fit Check.
Place palm of hand over exhalation valve cover and
reposition the respirator on the face and / or re-adjust
the tension of the elastic strap and / or the head harness
to eliminate the leakage. Repeat the above fit check. If
recommended that wearers should be fit tested in
CLEANING AND DISINFECTION
should be cleaned at the end of each shift and stored
between shifts in the original packaging or a sealed
should be used to wipe the face seal of the product.
moistened in warm soapy water (the water temperature
should be below 40°C) and dried at room temperature
in water.
57