Detergent and rinse aid ....
The detergent
Only use specific dishwasher detergents. The detergent
dispenser must be filled before each wash cycle begins
according to the instructions given in the "Wash cycle table".
The detergent dispenser is situated on the inside of the
appliance door.
Loading the detergent
To open lid "A", press button "B". The detergent should be
poured into the two containers "C" and "D" up to the rim.
After pouring in the detergent, replace the lid, pressing down
until it clicks.
Dishwasher detergent in tabs is now available on the market,
in which case you should place one tab into container "D"
and replace the lid.
If you prefer to use detergent in tablet form, place one of
these tablets inside the dispenser "D" and close the cover.
If the programme requires 2 tablets, the second tablet may
be placed directly inside the appliance, at the bottom.
B
D
A
Notice: To facilitate closing the cover, remove any
excess detergent on the edges of the dispenser.
Warning
If you use tablets that include salt function, we recommend you pour extra salt into the relevant dispenser to prevent the
formation of white streaks on your dishes or on the interior of the appliance.
If you use tablets that include rinse aid, it is no longer necessary to put rinse aid into the relevant container.
If you want to achieve perfectly dry dishes, you may add rinse aid as long as the dosage adjuster is set to no.2.
In any case, please read the manufacturer's instructions on the packet.
If you use only these products, it is normal for the salt and rinse aid indicator lights to flash permanently after a certain number
of cycles.
GB
All manuals and user guides at all-guides.com
C
Rinse Aid
This product makes dishes sparkle more as it improves their
drying. The rinse aid container is situated on the inside of
the door: It should be filled up when the low rinse aid
indicator light "F" flashes.
Loading the rinse aid
To open the dispenser, turn cap "C" anticlockwise and take
care when you pour in the rinse aid to avoid it overflowing.
You can adjust the amount of rinse aid used by the dishwasher,
by using a screwdriver to regulate the dosage adjuster "F"
you will find under lid "C". There are 6 possible settings; it is
normally set to 4.
Important:
Adjusting the rinse aid supply improves drying.
If drops of water remain on the dishes or spotting occurs,
turn the dosage adjuster to a higher setting. If, on the other
hand, the dishes have white streaks, then turn the dosage
adjuster down to a lower setting.
3-in-1 BUTTON
This dishwasher model is fitted with a 3-in-1 button. We
recommend you use it to obtain the best results from the
wash and dry cycles of your dishwasher when using 3-in-1
tablets.
14
F
C