Fcc Statement; Technical Specifications - Smoothskin PURE FIT Manual Del Usuario

FCC STATEMENT:

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
38

18. TECHNICAL SPECIFICATIONS

SmoothSkin Pure Fit is a filtered broadband Intense Pulsed Light system with the following technical
specifications:
• Repetition Rate: Manually pulsed every 0.45 to 1 second (dependent on treatment
setting), Continuous operation
• Pulse Length: Free discharge FWHM = 2.0ms
• Max Optical Output: 3 - 6J/cm2
• Wavelength: 510 – 1100nm
• Power Line Input: 100–240V~, 50/60Hz,1.7-0.91A
• Operating temperature: Between 5°C and 40°C
• Operating humidity: Up to 93%R.H. non condensing
• Operating Pressures: 700hPa to 1060hPa
• Treatment area (spot size): 3 cm (30mm x 10mm)
2
The area directly around the treatment window is classified as the Applied Part, and can reach a
maximum temperature of 60degC. Ensure SmoothSkin Pure Fit is used as directed in Section 8.
39