ABB SREA-50 Guia De Instalacion Y Inicio Rapida página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

10 Quick installation and start-up guide – SREA-50
SREA-50 start-up
Before you proceed, make sure that:
all inverters are connected to the RS-485 network
the inverter Modbus interface has been configured
the inverters are powered
the modem (if any) is connected.
Connecting the Ethernet network
The SREA-50 delivery includes an Ethernet cable. Connect the
cable directly between a PC and the adapter for start-up.
Note: After the start-up, you can start using the cable permanently
between the adapter and the Ethernet switch.
Powering up SREA-50
Power up the adapter and wait one minute for it to initialize.
Connecting to SREA-50 over Ethernet
The default Ethernet configuration of SREA-50 is:
IP address: 10.200.1.1
Subnet mask: 255.255.255.0
1. Configure your PC to the same subnet (for example, IP
address 10.200.1.2 and subnet mask 255.255.255.0).
2. Use, for example, Internet Explorer or Mozilla Firefox and go to
http://10.200.1.1.

Publicidad

Tabla de contenido
loading

Tabla de contenido