MTD 19B70028OEM Manual Del Operador página 10

24. Remove the click pins and slide the rod out of the brace
bracket assembly. Be sure not to lose the flange bearings
when removing the rod. See Figure 3-12.
Click Pins
25. Lift the back end of the brace assembly and line the holes
up with the holes in the mounting brackets (#10 or #12).
Slide the rod through the mounting brackets (#10 or #12),
flange bearings and the brace assembly. When in place,
re-install the click pins in the rod to secure it in place. See
Figure 3-13.
Mounting Brackets
Brace
Assembly
26. Tighten the front blade mount bracket hardware. Then
tighten the left and right hand axle brackets and the blade
mount bracket. Refer to Figure 3-9 and Figure 3-11.
10 S 3— A
ection SSembly
Rod
Figure 3-12
Figure 3-13
& S -U
et p
27. Reinstall the floor board. On the right side of the tractor
mount handle mount bracket (#11) to the frame with a hex
washer screw (#15) and spacer (#31) as shown in Figure 3-14.
Hex Washer
Screw
Spacer
Figure 3-14
28. Install the handle mount bracket (#11) using a shoulder
bolt (#6) and jam lock nut (#38). See Figure 3-15.
Handle Mount
Bracket
Jam
Lock
Nut
Figure 3-15
29. Re-install the pedals and tighten securely.
Handle Mount
Bracket
Shoulder Bolt