MTD 19B70028OEM Manual Del Operador página 8

12. For 2014 and newer tractors, the lift handle will need to be
replaced. Proceed to step 13 for 2014 and newer tractors.
For 2012/2013 tractors, skip to step 15.
13. Remove the hex screw and flange lock nut securing the
handle to the deck lift shaft assembly and remove the
handle. See Figure 3-4.
14. Install the new lift handle (#40) using the hex screw and
flange lock nut removed in step 13. See Figure 3-4.
15. Slide the new grip (#24) onto the handle.
16. Remove the screw on each side of the floor board as shown
in Figure 3-5, the four screws at the base of the steering
column and the three along the edge of the floor board
towards the seat.
Screw
8 S 3— A
ection SSembly
Figure 3-4
Figure 3-5
& S -U
et p
17. Remove three pedals to get the floor board off the tractor.
The drive/reverse pedals are secured with a hex screw and
the brake pedal is secured by a hex screw and flange lock
nut. See Figure 3-6. Remove the screws and the pedals.
Figure 3-6
18. Remove the flange lock nuts on the two hex screws on
the front bumper. To access the hex screws, the front of
the floor board must be lifted up and out of the way. See
Figure 3-7.
Hex Screws
Figure 3-7
Flange Lock Nuts