VONROC RS502AC Traducción Del Manual Original página 7

Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. Handle
2. Lock-on button
3. On/Off button
4. Handle unlock button
5. Auxiliary handle
6. Baseplate
7. Saw blade
8. Chuck
9. Clamping lever
10. Baseplate bolts
3. ASSEMBLY
Before carrying out any work on the
machine, disconnect the mains plug from
the power supply.
Replacing the saw blade (Fig. A, C)
When mounting the saw blade, wear
protective gloves. Danger of injury when
touching the saw blade.
Only use saw blades that correspond with
the characteristic data given in the
operating instructions.
Mounting the saw blade
Make sure the blade holder is free of material
debris (such as splinters of wood or metal).
1. Turn the clamping lever (9) as far to the left as
possible and hold it in this position.
2. Insert the saw blade in the chuck (8). Check
that the saw blade is securely fixed and that the
teeth are pointing downwards.
3. Let go of the clamping lever. Check whether the
saw blade is locked in place.
Make sure to use the right sawblade for the corres-
ponding material. Included with the machine is a
coarse sawblade for wood and a fine sawblade for
metal and plastics.
WWW.VONROC.COM
Removing the saw blade
1. Turn the clamping lever (9) as far to the left as
possible and hold it in this position.
2. Remove the saw blade from the chuck (8).
3. Let go of the clamping lever.
4. OPERATION
Switching on and off (Fig. A)
• To switch on the machine, press the on/off
switch (3).
• To switch the machine to continuous mode,
keep the on/off switch (3) pressed and simulta-
neously press the lock-on button (2).
• To switch off continuous mode, press the on/off
switch (3) again.
• To switch off the machine, release the on/off
switch (3).
Adjusting the base plate (Fig. B)
Due to its movability, the baseplate (6) angle
adapts to the workpiece. Furthermore, the length
of the baseplate can be adjusted depending on the
required sawing depth.
1. Loosen the baseplate bolts (10) using the hex
key provided.
2. Adjust the baseplate (6).
3. Tighten the baseplate bolts (10) using the hex
key provided.
Plunge cutting (Fig. D)
Plunge cutting may only be used on soft materials
such as wood, aerated concrete, gypsum plaster
boards, etc. However, this requires a certain practi-
se and is only possible with short saw blades.
1. Place the saw onto the workpiece and switch it on.
2. Ensure that the bottom edge of the footplate
rests on the workpiece surface as shown.
3. Slowly saw into the workpiece at an angle, mo-
ving the saw to a vertical position and continue
to saw along the cutting line.
4. Switch the saw off and lift off the workpiece
when the work is complete.
Flush cutting (Fig. E)
Elastic bi-metal saw blades allow you to saw
protruding objects (e,g, water pipes, iron bars, etc,)
nearby the wall.
1. Apply the saw blade directly to the wall and
bend slightly so that the footplate rests against
the wall. Pay attention that the saw blade
EN
7