VONROC RS502AC Traducción Del Manual Original página 8

EN
always extends beyond the diameter of the
material being worked.
2. Switch the machine on and saw off the workpiece
keeping constant lateral pressure against the wall.
Adjusting the main handle
Before starting operation you can adjust the main
handle (1) to the position most comfortable for the
task. The handle can be set up in 5 positions within
180° rotation range in long axis of the tool body
(90° left or right from the base position).
1. Move the handle unlock button (4) back.
2. Rotate the main handle around long axis of the
tool to desired position (fig. F).
3. The main handle automatically locks in desired
position.
Optimum use
• Adjust saw blade and stroke rate to suit the ma-
terial to be processed. For right radius curves it
is best to use a narrow saw blade. Apply coolant
or lubricant to deal with the fluttering produced
along the cut line when sawing metal.
• Check wood, chip boards, building materials
etc, for hard materials (nails, screws etc.), befo-
re sawing and remove them, if necessary.
• Clamp material well. Do not support the workpie-
ce with hand or foot. Do not touch objects or the
floor with the saw running (danger of backlash).
• Put the footplate on the surface of the workpiece,
and saw through it with constant contact pres-
sure or feed. If the saw blade seizes switch the
machine off immediately. Spread the gap with a
suitable tool and pull out the saw blade.
• After finishing work, switch off the machine and
only put down after it has come to a complete
standstill.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that the
ventilation openings are free of dust and dirt. Re-
move very persistent dirt using a soft cloth moiste-
ned with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
8
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of defects
in both materials and workmanship for the period
lawfully stipulated starting from the date of original
purchase. Should the product develop any failure
during this period due to defective material and/or
workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by compa-
ny either expressed or implied. There are no other
warranties expressed or implied which extend
beyond the face hereof, herein, including the im-
plied warranties of merchantability and fitness for
a particular purpose. In no event shall VONROC be
liable for any incidental or consequential damages.
The dealers remedies shall be limited to repair or
replacement of nonconforming units or parts.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
WWW.VONROC.COM