Suzuki 990D0-15H00-ALM Instrucciones De Montaje página 5

Fitting Instructions
EN
STEP-BY-STEP FITTING GUIDE HAYABUSA
Photo A: Connector functions; (3) LED, (4) Direction indicator lights, (5) for alarm system.
Connect the alarm harness main connector to the alarm control unit, fit the rubber hood in place (1) and
secure it with a plastic tie (2).
Photo 1: Remove the main saddle (A), the passenger saddle (B) and the passenger handgrip (B1) and
remove the rear faring (C).
Photo 2: Find the two bracket mounting holes on the left-hand side of the rear frame (D).
Photo 3: Fix the alarm assembly to the bracket with the siren facing downwards, using two plastic ties
(E). Fix the alarm assembly and the bracket to the two holes identified earlier (F). The screws needed
to do this (L=16mm) are provided in the installation kit.
Photo 4: Route the alarm harness and secure it with the plastic ties (G).
Photo 5: Find the alarm connectors on the left-hand side of the motorcycle (H).
Photo 6: Make the electrical connection to the alarm connection (I) and also connect the six-pin connector
of the rear light (L).
Photo 7: Fix the LED to the frame and make its electrical connection to the alarm harness (M).
Reassemble all the parts removed earlier and take care to tighten all the screws.
HOW TO ENABLE THE ALARM SYSTEM
Enabling the alarm system
The alarm must be initiated to make it operational. To do this, turn the ignition key OFF-ON-OFF.
The alarm system's LED (Photographs 6-7 for GSX-R and Photographs 7 for Hayabusa) will now flash,
indicating how many remote controls have been paired up to the system by flashing the appropriate
number of times (two are supplied as standard).
The system is now operational. Please refer to the user manual, supplied with the Alarm Kit item code
990D0 – ALARM – 000 for further details and specifications.
State of the art. 11/2007
5
SUZUKI GENUINE ACCESSORIES