Lp Gas Conversion Instructions; Before You Begin; Lp Conversion Preparation; Disassembling The Cooktop - Thermador PROFESSIONAL Pro Harmony PRD305PH Manual Del Usuario

LP Gas Conversion Instructions

Before You Begin

CAUTION
BEFORE PROCEEDING WITH THE CONVERSION,
SHUT OFF THE GAS SUPPLY TO THE APPLIANCE
PRIOR TO DISCONNECTING THE ELECTRICAL
POWER.
TOOLS NEEDED
Scissors
T-30 Torx screwdriver
T-20 Torx screwdriver
1/4" nut driver
7/8" socket or adjustable wrench
Flat-head screwdriver, 1/8" X .020" blade (included)
LP GAS CONVERSION KIT ITEMS INCLUDED
DESCRIPTION
Foam Tape, 1" piece
Propane Conversion Label
®
STAR Burner Jet Orifice (1.1 mm)
®
STAR Burner Jet Orifice (#70)
®
STAR Burner Jet Orifice (#62)
®
STAR Burner Jet Orifice (#64)

LP Conversion Preparation

1. Shut off the gas supply to the appliance prior to
disconnecting the electrical power.
2. Cut a 3/8" long piece of the adhesive foam tape. Place
foam tape over the edge of the nut driver used to
replace the burner orifices, as shown.
• The foam tape helps to
retain the orifice in the end
of the nut driver so it will
not fall inside the appliance
during orifice removal or
installation.
English 2

Disassembling the Cooktop

IMPORTANT: Ensure that the power is turned OFF at
the breaker and the gas supply is turned OFF.
1. Remove the cooktop grates.
2. Remove the burner caps.
3. From each burner base, remove the two burner base
screws with a T-30 Torx screwdriver.
QUANTITY
1
1
1
2
4. To facilitate the removal of the spill trays, depending on
1
model, remove the (3) or (4) T-20 Torx stainless screws
1
in the front face of the included Flush Island Trim.