Model Identification - SAF-HOLLAND FW16 Manual De Reemplazo

Model Identification and Replacement Procedures
2. Model Identification
These instructions contain the installation procedures for
the SAF-HOLLAND ® replacement kit RK-161-11493. Before
replacement, verify that the replacement kit for the fifth
wheel top plate is correct for the attempted repair.
Fifth wheel serial tags are located on the left side of the fifth
wheel top plate above the fifth wheel bracket pin, or on the
pickup ramps. The part number and serial number are listed
on the tag as indicated (Figure 1).
3. RK-161-11493 Kit Contents
ITEM DESCRIPTION
1 Release Handle
2 Washer, 1/2" SAE
3 Cotter Pin
4 Extension Spring, Inner
5 Extension Spring, Outer
4. Top Plate Removal
1. Clean off excessive grease, grime, and dirt from top plate.
2. Remove bracket pin retention bolt and nut from both
sides of fifth wheel top plate (Figure 3).
3. Using a pry bar, pull bracket retention pins out of fifth
wheel top plate (Figure 3).
4. Using a lifting device capable of lifting 500 lbs. (227 kg),
remove top plate from mounting base. Place fifth wheel
upside down on a flat, clean working area.
NOTE: Follow instructions published by lifting device
manufacturer for proper operation of lifting device.
2
(Figure 2)
PART NUMBER QTY.
XA-11618-RP-P 1
XB-PW-1732-1-116 1
XB-16 1
XB-10489 1
XB-10490 1
XL-FW10084RM-en-US Rev B · 2014-01-29 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
Figure 1
U.S. AND FOREIGN PATENTS APPLY
Model No. XXXXXXXXXXXX
Serial No. XXXXXXXXXXXX
FAILURE TO PROPERLY INSTALL, MAINTAIN & OPERATE
THIS PRODUCT COULD RESULT IN TRACTOR TRAILER
SEPARATION CAUSING SERIOUS INJURY OR DEATH.
Figure 2
1
Figure 3
TOP PLATE
BRACKET PIN
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
MADE IN
XXXXXX
5
4
2
3
RETENTION
BOLT
RETENTION
NUT
PRY BAR